Dynasonics UFX ULTRASONIC FLOW METER Bedienungsanleitung

1 MODEL UFX ULTRASONIC FLOW METER Operating Instructions

10 Figure 3 Apply an even layer of grease, approximately ⅛" (3 mm) thick to the flat surface of the transducer. Place the transducer on the prepa

11 H. CONVERSION FROM VELOCITY TO VOLUME The velocity readings taken from the UFX can be readily converted to volumetric flow rate measurements such

12 TROUBLESHOOTING GUIDE Unit does not turn “ON” when ON/OFF key is pressed • Verify that batteries are installed and contain a charge. “Err1” is indi

13 LIQUID VELOCITY TO VOLUME CONVERSION CHART

14 STATEMENT OF WARRANTY Dynasonics, Division of Racine Federated Inc. warrants to the end purchaser, for a period of one year from the date of ship

15 SPARE PARTS AND ACCESSORIES PART NUMBER DESCRIPTION D002-2007-001 SS Mounting Strap, 36 inch [900 mm] D002-2007-002 Nylon Mounting Strap,

16 © 2011 Racine Federated Inc. All rights reserved. Printed in the USA UFX O&M REV 01/11 8635 Washington Avenue Racine, WI 53406 Toll-Free in

2

3 TABLE OF CONTENTS • Quick Start Instructions 4-5 • Introduction 6 • Specifications 6 • Controls and Terminology 7 • Transducer Mounting

4 QUICK-START INSTRUCTIONS This manual contains detailed operating instructions for the UFX instrument. The following condensed instructions are provi

5 E. Apply approximately ⅛ inch [3 mm] silicone grease to the transducer face. Place the transducer face on the prepared area of pipe. Hold the transd

6 INTRODUCTION AND OPERATING THEORY Series UFX Phase Shift Flow Meters feature advanced Trans-Phase measuring technology, providing accurate and relia

7 CONTROLS AND TERMINOLOGY Transducer Cable Display Transducer Jack Transducer Plug Keypad Transducer NOTE: The UFX battery compartment is located o

8 A. TRANSDUCER LOCATION Selecting the proper location for taking a flow measurement is the single most critical step in the operational procedure. T

9 B. MOUNTING LOCATIONS ON THE PIPE If the transducer is applied to horizontal pipe, choose a mounting position at approximately 3 o’clock or 9 o’clo